Uponor Minitec Underfloor Heating

Uponor Minitec Low-Profile Underfloor Heating

Uponor Minitec is a low-profile, water-based underfloor heating system designed for renovation and retrofit projects. With a total system build-up of approximately 15mm before the final floor covering, it is ideal for rooms where increasing the floor height needs to be kept to a minimum.

The system combines self-adhesive Minitec panels with flexible 9.9mm Uponor PE-Xa pipe. It can be installed over suitable existing screed, timber or tiled floors, subject to the correct preparation and levelling compound being used.

Why Choose Uponor Minitec?

• - Only 15mm system build-up: A practical solution for renovations, extensions and individual room upgrades where floor height is restricted.
• - Fast response times: The small-diameter pipe sits close to the finished floor surface, allowing the system to warm up and respond quickly.
• - Suitable for low-temperature heating: Minitec can operate at lower flow temperatures, making it well suited to compatible heat pumps and other efficient heating systems.
• - Secure pipe positioning: The castellated panels hold the pipe firmly in place and allow it to be installed in straight runs and 45° or 90° bends.
• - Flexible room layouts: Panels and pipe can be fitted around doorways, columns and other obstacles, making the system suitable for rooms with more complex shapes.
• - Strong self-adhesive panels: The panels bond to a suitably prepared substrate and can be walked on during installation.
• - Compatible with different floor finishes: Once the correct levelling layer has been applied and fully cured, a wide range of compatible floor coverings can be installed.
• 
  

Designed for Renovation Projects

Traditional underfloor heating systems can require a substantial floor build-up. Uponor Minitec provides the comfort of water-based underfloor heating while minimising the impact on existing floor levels, thresholds and door heights.

The perforated panel design allows the approved levelling compound to flow through the panel and bond securely with the prepared subfloor. Because the heating pipe is positioned close to the finished surface, the system provides even heat distribution without the deeper screed layer associated with conventional underfloor heating.

Build Your Uponor Minitec Pack

Our Uponor Minitec pack builder makes it easier to select the components required for your project. Simply enter the heated floor area and number of heating zones, and the pack will be calculated for you.

Build Your Uponor Minitec UFH Pack

Always check that the existing floor construction, insulation, levelling compound and proposed floor finish are suitable before installation.